Operation Manual for Pneumatic 310ml PUR Hot Melt Adhesive Gun



1. Take out the 310ml aluminum tube PUR hot melt adhesive, pull open the tail pull ring, remove the desiccant, and use a sharp tool to poke several holes in the tail extrusion plug (PUR adhesive with good sealing does not need to be punctured). The front thread of the adhesive also needs to be punctured with a sharp tool before the adhesive can come out, as shown in the example below.

2. Place the PUR adhesive into the gun body and tighten the back cover, as shown in the picture.

3. Take out the adhesive conversion head and hold it at the PUR adhesive thread (white tape needs to be wrapped around the PUR adhesive thread to ensure its sealing and prevent adhesive leakage). Then lift up the adhesive nozzle, as shown in the figure:

4. Plug in the power supply, the digital display thermostat can adjust the temperature from 0 to 200 degrees and switch freely according to your own temperature. The maximum factory temperature is 160 degrees, and if it exceeds 160 degrees, please set it yourself.

technical parameter；